QRP Smarty Load
May 16, 2018
Introduction
Our 21st century take on a classic piece of Ham Radio gear - we took a run of the mill QRP dummy load design and added an Arduino to create the Smarty Load. This project features:
- Up to 25 watts (Caution! This unit will get hot - recommended to run with ventilation or a small fan to assist in...
QRP Dummy Load
May 16, 2018
Introduction
Another perfect introduction to soldering, this project is a QRP Dummy Load rated for up to 25 Watts with an LED that indicates the presence of RF. Caution! - This unit will get hot! Use with good ventilation and maybe a small fan to dissipate heat!
Documentation
12V DC Outlet Strip
May 15, 2018
Introduction
A perfect introduction to soldering! The Ham Radio Workbench 12V DC Outlet Strip allows you to share a single 12v power source across four other devices. This project features:
- Designed for Anderson Powerpole Connectors
- Total current capacity not to exceed 25 Amps @ 12V nominal
- Four fuse holders that...
4-Port Programmable Coax Relay
May 13, 2018
4-Port Programmable Coax Relay
Introduction
Allows you to connect one radio to four antennas or four radios to one antenna. Need a sophisticated 4 to 4 matrix? Purchase two and you can write custom firmware to connect any one of four ports to any one of another four ports. This project features:
- Connects one of...
Ham Radio Workbench Project Board Index
May 1, 2018
Below, you will find an index of our products that are currently in production. For more information, follow us on Twitter or check out our Facebook Group.
Legacy build documentation can be found at
